Walrus Audio Fundamental Series Distortion

Walrus Audio Fundamental Series Distortion
For the Fundamental Series, we challenged ourselves to design a set of pedals with the tonal integrity that’s required to live on a professional’s pedalboard , but with simplified controls friendly enough for even the newest effect pedal users. Each Fundamental pedal has 3 sliders for tweaking the sound and a three - way switch for changing pedal modes. The result is a line of 8 pedals that will keep you covered from your first band practice all the way to a sold - out arena. Designed and assembled at Walrus Audio headquarters in OKC, OK.
Fundamental Distortion
The Fundamental Distortion is a 3
- mode distortion. It covers a wide range of sounds from dark and doom t hrough sharp cutting leads.
Gain
– The Gain slider sets the amount of gain applied to your guitar signal passing through the fuzz circuit.
Tone
– The Tone slider controls the frequency response of the signal after distortion. Below center boosts highs and above center cuts highs.
Volume
– The Volume slider sets the overall output volume of the pedal.
Slide Switch
– The slide switch allows you to change between 3 distinct flavors of the pedal. Each position has different clipping modes or tone profil es.
Dark
- Asymmetric silicon clipping with added high - frequency cut. Think dark and dynamic.
Si
- Classic silicon hard clipping diodes. Things get compressed and crunchy.
LED
- LED hard clipping diodes. A dynamic and crunchy so und. Note: The LED clipping mode will be louder due to the nature of the LEDs, so use your volume slider to compensate!
Bypass Switch
– Turns the effect on and off.
Bypass LED
- Illuminated when the effect is engaged.
Trails Modes
– Hold down the stomp switch when applying power to the pedal.
Input Jack
- 1/4 inch cable from the instrument. Output Jack - 1/4 inch cable to amplifier.
9v Jack
– 9 - volt DC, Center Negative, 100mA min.